![]() ![]() If your hatch scale is completely independent of any stretching of the hatch boundary, then place an additional stretch action associated with the same parameter that the hatch is associated with, add the hatch boundary to that stretch action, and set the distance multiplier for that stretch action to 0. Place it on a non-plotting layer if you do not want it to show. It is better to use a single closed polyline for the hatch boundary. Clean up your drafting errors (the side lines you use for a boundary are not even vertical). and you're the one wanting me to spend my free time assisting you and so the added time burden is more appropriately placed on your end. It is also more work on my end to add linear parameter, lookup, etc. It would have been better to post the block *with* your attempt to follow the above outlined solution as it would be easier to point out the error. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |